HOW TO CREATE A BIRD HOUSE

How to Build a Bird House
Assembly Instructions:


1. Before proceeding with each joint, start the nails, tapping into position, then apply waterproof glue along the joint edge.

2. Butt and glue the two bottom sides together as shown in Fig.1

3. Next, glue and nail the back section to the bottom sides.

4. Glue and nail the inside supports; see Fig. 1 for positioning on the back.

5. Using the 1 3/8 hole saw, drill a hole in the front section so that the top of the hole is 2" down from a corner; see finished photo for detail. Use a 1/4" bit to drill a hole for the dowel perch, 5'8" below the bottom of the larger entrance hole. Sand the edges smooth, and sand all other inner parts of the bird house before nailing down the front.

6. Glue and nail the front to the bottom sides and the inside supports.

7. Position roof sections so that they meet, but do not butt at the top. Glue and nail the roof sections into place. The roof overhangs the sides, as shown.

8. Glue the 5" dowel in the channel between the roof sections to complete this joint.

9. Sand all surfaces.

10. Lastly, glue the 3" dowel into position as a perch.

Your bird house is now ready to stain or paint as desired.

Note: The size of hole that you make in your bird house and its height above ground will determine, in part, what kind of bird your bird house attracts. For help in choosing these important dimensions, see our article on Building the Right Bird House.
thanks to the website of allfreecrafts.com